ftdi pl2303hx usb to serial adapter driver

If Windows does not automatically load the proper driver, a caution If this occurs, you Must backdate your driver to 3.2.0.0 It was done to prevent use of the cloned chip. The cable is inserted into the radio, the transmitter will turn on. This When opening Device Manager, the Yellow Caution Triangle may not appear, however, when Windows may attempt to automatically load the Prolific driver 3.6.xx.xxx when inserting your cable. The last compatible Prolific driver was v3.3.2.105. The latest driver installed by Windows (Vista, 7, 8.1 and 10) is not compatible with these chips. Nearly every programming cable that is detected by Windows as having a Prolific chip was manufactured with an unauthorized or cloned copy of the Prolific PL2303HXA chip. Not, the driver and procedure can be found at this Link.ĭrivers for the Silicon Labs chipset (CP210x) should alsoĭownload automatically. The driver should also download automatically. Many Baofeng and generic programming cables are shipping with the WCH chipset (CH340/341). Not all provided CDs come with the correct drivers.īy using Windows Device Manager, you should easily be able to determine whichĬables with FTDI chipset (FT232R) will automatically download the Not all cables load the correct driver automatically. because it does not have the DTR/RTS wire necessary for initiating the bootloader reboot sequence.Programming cable Must have the correct driver installed This cable is not good for Arduino re-programming such as a BBFuino, Pro-Mini, etc. Note that we call this a 'TTL cable' (since that's what they're called) but technically it's CMOS logic. This is easier to use than an FTDI cable in many cases because the wires are separated.

If you are running Linux, drivers are already included in the kernel, no need to install anything!Īlso handy for hacking WiFi routers to install alternate OS's, or nearly any other 3.3V logic serial port. If you are running Mac OS X, check this tutorial page with links to drivers for both PL2303 and CP2012

If you are running Windows 7/8/10 etc, check this tutorial page with links to drivers for both PL2303 and CP2102

Connect the pins as shown to power the Pi or BBB and establish the RX/TX link. The power pin provides the 5V 500mA direct from the USB port and the RX/TX pins are 3.3V level for interfacing with the most common 3.3V logic level chipsets.īecause of the separated pin plugs, this cable is ideal for powering and connecting up to the debug/login console on the Raspberry Pi or BeagleBone Black. Inside the big USB plug is a USBSerial conversion chip and at the end of the 1 meter cable are four wire - red(power), black (ground), white (RX) into USB port, and green (TX) out of the USB port. The cable is easiest way ever to connect to your microcontroller/Raspberry Pi/WiFi router serial console port. Lithium Ion Rechargeable Battery and Charger.

Ftdi pl2303hx usb to serial adapter driver